10-12-2015, 05:23 PM
|
|
CC Member
|
|
|
Join Date: Oct 2015
Cobra Make, Engine:
Posts: 6
|
|
Not Ranked
Apparently knowing what those little brass things are, what they do and where they go is only half of the battle. I cannot figure out how the heck the two brass pieces and the little felt washer get to where they are supposed to be. I know it's got to be some kind of Rubik's Cube trick, but I was never any good at those either. Does anybody have any idea how these pieces install?
All is well. I was trying to install them without bending the little retainer. It can't be done. Once I bent the retainer down, the pieces slid into place easily. Then it was just a matter of bending it back up with a small pair of needle nose plyers.
Last edited by tdyltc66; 10-12-2015 at 05:43 PM..
|
Threaded Mode
