upgrading Ford GT aluminum heads

SPF1061 · #1 (**permalink**) 11-26-2002, 08:30 AM

I just read a magazine article that claimed swapping the Ford aluminum GT heads out for a pair of Air Flow Research 185cc heads on an otherwise unmodified SVO 392 crate added 75hp and mucho torque across a very broad rpm range (1500-6500 I think). Is anyone running Air flow, Edelbrock, Trick Flow, or ? heads on their SVO 392s with the original roller cam? Comments, thoughts, advice?
TIA
SPF1061

got snake? · #2 (**permalink**) 11-26-2002, 09:21 AM

There are plenty of guys running AFR heads on this board. I'm pretty sure they will advise you well. But I also recommend you type in AFR in the search page or under user name type in andy dunn.

GS

kountzecobra · #3 (**permalink**) 11-26-2002, 10:24 AM

I have a set of the smaller AFR 165 heads on a 289 and they are great! The 289 pushes a 63 Galaxie very well!

RACER X #99 · #4 (**permalink**) 11-26-2002, 02:18 PM

TIA,
check here. Research the articles look for 75 hp bolt on.

http://www.airflowresearch.com/

Curt C. · #5 (**permalink**) 11-26-2002, 03:39 PM

I am famillar with that article - its a good one. Just remember that the pistons have to be notched to accomdate that head. Also, the head used in the 75 hp increase article had been milled. I do not remeber if they could run that combo on pump gas. This info may be in the AFR link posted above. I did not check.