10-29-2008, 12:25 PM
|
 |
CC Member
|
|
|
Join Date: Sep 2002
Location: Baton Rouge, Louisiana,
La.
Cobra Make, Engine: Waiting to Order a BDR, engine to be a SA C408. TKO to hook it up.
Posts: 1,259
|
|
Not Ranked
Spinning a mill to 8k with 425hp is easily doable. Not cheap for sure but many good engine builders will be able to deliver that.
If you want to go a little further ....... give these guys a call
http://www.coatesengine.com/index.html
With their heads on a strong bottom end you could spin it north of 10k. The fuel system would need careful design to keep up - but again any good builder will be able to do that. It would sound .... interesting.
__________________
Pull a gear .... drop the hammer .... and enjoy the Drive !!
|
Threaded Mode
