09-12-2009, 12:05 PM
|
|
CC Member
|
|
|
Join Date: May 2006
Location: Kuna,
ID
Cobra Make, Engine: Hurricane Motosports
Posts: 149
|
|
Not Ranked
Solid roller lifter failure
I had one of my roller lifters have the needle bearings fail. These are not pressure fed like some on the market. Just checking to see if this is common . My cam was damaged a bit but was able to have it repaired. I have a little under 5000 miles on it. Just wanted to see what other members have had good luck with. I am looking at the comp cams solid roller lifters that are pressure fed. Any suggestions would be appreciated. My lifters are the top ones on this hyper link page http://camresearchcorp.com/ Thanks Bermblaster
Last edited by bermblaster41; 09-12-2009 at 12:10 PM..
|
Threaded Mode
