All SPF owners check area under pass side pipe

[ha_pe_1968]

Originally Posted by Mark IV

Also remember there are spacers to use under the engine pedistals to center the pipe in the opening as well as the "wedge" spacers for the sidepipe to header connection. The wedge spacers can raise, lower or move the sidepipe fore/aft in the opening.

A friends MK III needed a wedge on the left side to raise the pipe away from the bottom of the opening. We didn't want to raise the left side of the motor as it was within 3/16" of being level in the chassis.

Hi!
Have the same problem..the left side is perfectly centered but the right side is lower as it should be in the openening. So the wedge spacer could be the solution. Do you have any pics of it and an idea where i can buy it?

Thanks a lot!
Peter

[Mark IV]

We carry them or go to New Page 1

Remember you will now need two gaskets for the header to sidepipe connection.

[ha_pe_1968]

Originally Posted by Mark IV

We carry them or go to New Page 1

Remember you will now need two gaskets for the header to sidepipe connection.

Hi!

Thanks a lot! Will measure what i need and if it will work. Will order at
you because you gave me the right direction :-)

Peter

PS: Sorry for OT madmax

[madmaxx]

Slow down. none are perfectly centered. If you don't have the poly mounts install them first. the only time a wedge is needed is if the pipe does not run parallel to the body. if you want to spend money give me call and you can send me a check. 99% of the time with stock pipes it just requires a flat shim under the motor mount. the wedges will make a drastic change and have never seen a wedge required to "center" the pipe in the hole.

Originally Posted by ha_pe_1968

Hi!
Have the same problem..the left side is perfectly centered but the right side is lower as it should be in the openening. So the wedge spacer could be the solution. Do you have any pics of it and an idea where i can buy it?

Thanks a lot!
Peter