SPFR 0012 is just waiting for it's SB100.

[Moto One]

Originally Posted by Blas

Look at the jack that comes with a Mercedes C300. Very compact. And I think that with a modification to the end that the round chassis tube sits on, would work well. Unless you want something more original and want to display it in the boot.

After digging in the basement, I found an old Volvo jack, and with a mod to the pick up point it's going to do the job just fine. Not worried about originality.

Now about rear wheel bearings. I was checking over the car before going to Monterey (witch I have canceled) and found a lot of grease oozing from the seal on the back side. I'll have to look deeper into it, there is no noise, or play, and the wheel turn freely. There was also grease spray from all four CVs with no visible tears in the boots. Oh the fun. Progress was made with the injection (somewhat) after balancing them, still need to get a DOS computer to do a fine tune to the system (bola 8 stack, Fast ECM).

By the way we are at 2200 miles.

Mark.