TWM Induction systems for your Cobra from Thor Motorsports.

[Peo]

I have a Dax Cobra that is sixteen years old, with a 351 Clevland (stroked ) 2v closed chamber motor.Ten years ago I purchaced an induction kit from TWM with 4 50 mm twin barrel throttle bodies, complete with a formula 1 type air cleaner and matched it up with Motec M48. I had to have the manifold made, it is a flat two piece manifold. I tried a Redline manifold but was not happy with the porting from the factory, the ports were all out of sync. I am just writing to tell anyone who is interested that the TWM Induction system is fantastic. My problem has been getting an expert to tune the car , finally after all these years I have got it running beautifully. I have installed a roller cam and she flies, approx 500 hp at rear wheels. I connect the motor to a Tremec 5 speed box and a Centre Force clutch.If anyone has some tips to maximise the TWM system please let me know. Cheers Peo

[thorconstr]

I use FAST cpu and can usually find a technician close to do the tuning all over the US. Most cpu makers keep track of their approved techs. If anyone has a problem finding a tech, I will research it for you. Good to hear you've got yours performing well.

[greg schroeder]

Does anyone have one of these set ups in the Phoenix, Arizona area on a stroked small block. I'd like to see if it is an advantage to usable power for in line acceleration.

[thorconstr]

I have a setup on a big block in Tucson. Here is a dyno sheet for a small block. http://www.twminduction.com/v8_kits/dyno_sheet.html

[Rwillia4]

Greg,

I have a stroked SBF with TWM setup from Keith Craft. Here is my shaft dyno sheet. I'm in the San Diego area let me know if you make it out his way.

Rob