TKO600 clutch

[RICK LAKE]

elmariachi Jim Grade 8 Allen head bolts will work if you don't like 6,8 or 12 point bolts. I use them on my bellhousing to block in my ERA They give you more room to install and remove with a socket or wrench that has been cut down. Pat does have the right ideas about marking bolts and nuts for checking during maintainance look overs. Rick L.

[elmariachi]

Originally Posted by RICK LAKE

elmariachi Jim Grade 8 Allen head bolts will work if you don't like 6,8 or 12 point bolts. I use them on my bellhousing to block in my ERA They give you more room to install and remove with a socket or wrench that has been cut down. Pat does have the right ideas about marking bolts and nuts for checking during maintainance look overs. Rick L.

When I rechecked them, I tick-marked them with a silver Sharpie. We'll see.

[patrickt]

Originally Posted by elmariachi

When I rechecked them, I tick-marked them with a silver Sharpie.

Ahh, I did the same. You can see how careful I was in making the black mark.

[RICK LAKE]

patrickt The picture is a little rough. The metal is a balance weight for the pressure plate. Where are we going???? Rick l. Ps I have 2 on my pressure plate, one is bigger than the other one.

[patrickt]

Originally Posted by RICK LAKE

patrickt The picture is a little rough. The metal is a balance weight for the pressure plate. Where are we going???? Rick l. Ps I have 2 on my pressure plate, one is bigger than the other one.

Just checking to make sure you were still awake.

[elmariachi]

Originally Posted by patrickt

Just checking to make sure you were still awake.

I am convinced Rick never sleeps, and consumes a LOT of caffeine.

[patrickt]

Originally Posted by elmariachi

I am convinced Rick never sleeps, and consumes a LOT of caffeine.

Yep, and even I tread lightly when I intentionally provoke him.