05-30-2010, 08:51 AM
|
 |
CC Member
|
|
|
Join Date: Nov 2006
Location: Gig Harbor,
WA
Cobra Make, Engine: BDR#499 351W with Webers
Posts: 268
|
|
Not Ranked
Dallas,
I called Inglese last week and spoke to a guy named Chuck Gleaves he was very helpful and got me hooked up with a side/center pull linkage…Only sold me the parts I needed to make the conversion, not the entire kit. He saved me over $175.00. I completed the test fit yesterday and it works great! I have not run the engine with the set up yet, because I need to replace the base gaskets and the old ones will take a while to get off, as they are glued down.
Chuck also had a number of suggestions as to jetting, E-tube sizing, etc. He said it took him about a year to perfect the tune for the 351W. Mine is very close to what he suggested with the exception of E-Tubes. I am running F7s and he suggests F16s. I may change sometime in the future.
I do have photos of the set up, but they are too large to post here. Maybe I can put them in my gallery…
Gun Doc
|
2Likes
Threaded Mode
