10-06-2012, 01:13 PM
|
 |
CC Member
|
|
|
Join Date: Oct 2012
Location: Marion,
TX
Cobra Make, Engine:
Posts: 19
|
|
Not Ranked
The gas is new and I've spent 10 hours plus cleaning all the carbs. I have had the screws out in those locations and still same result.
I know for a fact it is lean because if it was rich it would still run much better than it does now. When I went up in size on the idle jets alone my hole was getting smaller but never got it decent. I'm wondering if the jets are ok but when I open it up a bit I can't flow enough through the holder..
If I need to get the 100 and 60 I will and I'm going to open up the 120 holder a bit and see what happens keeping te 65s. I know my main jet air corrector and emulsion are good so that's not an issue.
|
Threaded Mode
