Fuel system for Weber IDA 48 need help

Eljaro · #1 (**permalink**) 04-06-2007, 08:37 AM

entdoc
exactly those two damn leaking gaskets at both sides of the banjo or fuel block can be replaced by the Stat-o-Seal gaskets. These are very similar to seals used in hidraulics, basically a metalic washer with an o-ring embeded in the inside. Works wonders!

ENTDOC · #2 (**permalink**) 04-06-2007, 10:50 AM

Summit carries them, I will order today. chuck

G.R. · #3 (**permalink**) 04-06-2007, 05:29 PM

I use a Ford Racing mechanical pump and Aeromotive fuel pressure gauge and a Holley fuel pump regulator on my 289 SB. Canned the Holley electric pump a couple of years ago.

The car runs quite well with the mechanical pump.

big deuce · #4 (**permalink**) 03-11-2012, 09:30 AM

Quote:

Originally Posted by Eljaro

entdoc
exactly those two damn leaking gaskets at both sides of the banjo or fuel block can be replaced by the Stat-o-Seal gaskets. These are very similar to seals used in hidraulics, basically a metalic washer with an o-ring embeded in the inside. Works wonders!

I too an looking for the correct washers, but my fuel block is the one pictured. I like the small design of the Dowty seals, but not sure of what size. I also need the correct banjo bolts for this block. Any suggestions?