05-31-2016, 04:50 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: May 2001
Cobra Make, Engine: A CSX Cobra,1966 GT350 and an '06 Ford Heritage GT
Posts: 1,829
|
|
Not Ranked
Well, if you pull the intake again use an angle finder to measure the intake mounting location and the intake itself--they should match. Sometimes you can dry mount the intake and just look; the intake will be sitting too high vs. the heads if the heads have been milled. I sure hope everything turns out OK--a bummer this happened to you!
__________________
"I think we have more machinery of government than is necessary, too many parasites living on the labor of the industrious." Thomas Jefferson
|
6Likes
Threaded Mode
