Strange Heat Issue

[BOBOCobra]

Sorry, I should have clarified, I plugged that bypass over 4 years ago and I left it plugged after the rebuild. Heat issue is new. I was just splaneing how it is set up and did not clarify the timeline. It's easy to reattach and maybe I will give it a go, but that would be a strange turn of events. I have to say, outside of a stubborn air pocket it would be the only explanation. I'm going to swap probe locations and see what they tell me. Might be a bad mechanical gauge but they are usually pretty dead on.

[BOBOCobra]

Just to circle back and close this out, swapped probe locations, no change, burped a little, no change. Changed the Fitech probe and viola!!!! Bad sender, temps are running dead nuts. Glad I didn't tear out the intake!!!! What upsets me a bit is the Fitech controls my fans and they were kicking on 30 degrees late. I had set them up at 170 to be safe so it was actually almost 200. That sender was flat out wrong by almost 30 degrees.

[cycleguy55]

Originally Posted by BOBOCobra

Just to circle back and close this out, swapped probe locations, no change, burped a little, no change. Changed the Fitech probe and viola!!!! Bad sender, temps are running dead nuts. Glad I didn't tear out the intake!!!! What upsets me a bit is the Fitech controls my fans and they were kicking on 30 degrees late. I had set them up at 170 to be safe so it was actually almost 200. That sender was flat out wrong by almost 30 degrees.

Good to know you've solved the problem. Damn technology!

Enjoy the ride.