Edelbrock Pro-Flo 4 EFI

[Dana E.]

Originally Posted by cycleguy55

Anybody have experience with the Edelbrock Pro-Flo 4 EFI setup, particularly on a 385 Series engine?

https://www.edelbrock.com/edelbrock-...nes-35680.html

I have the Pro-Flo 4 on a 377" small block Chevrolet in one of my cars that dynoed at 440 horsepower and 464 torque. I've only got a few hundred miles on the system, but it has been working very well so far. It's a good value since it comes complete with the manifold and distributor.

[Steve Gallegos]

I have a proflo-4 on my stroker 351. When I bought the car new in 2008 I had the proflo-2 put on, work great until last year, control module went out, so put on the 4. Runs great, but you need someone who knows how to install it and set it up. Not just anyone can do it.

[Dana E.]

Originally Posted by Steve Gallegos

I have a proflo-4 on my stroker 351. When I bought the car new in 2008 I had the proflo-2 put on, work great until last year, control module went out, so put on the 4. Runs great, but you need someone who knows how to install it and set it up. Not just anyone can do it.

Installing the Pro-Flow 4 is not rocket science. If you can read an instruction manual and possess some basic mechanic skills, the installation and setup is not difficult at all.