
07-13-2002, 09:19 AM
|
 |
CC Member
|
|
|
Join Date: Dec 2001
Location: Castalia,
Oh
Cobra Make, Engine: EM cobra, 450 inch sbc running a best ET of 9.14..so far..ALL MOTOR...approx 800 horse.............ERA with 482 FE..All Aluminum Engine
Posts: 1,395
|
|
Not Ranked
The break I'm using comes from McClintic.....
9701 Trumbull SE
Albuq. NM 87123
505-292-1311
McClinticrdm@aol.com
basically what you have is an aluminum cylinder that screws apart. Inside is a plunger sitting on top of a spring sitting on top of shims...the shims control when the break will open. Reading their brochure, the shim is .025 thick, and each shim is approx 2.5 inches of vacuum.
__________________
Jack
XSSIVE .....
|