09-30-2006, 06:31 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Mar 2000
Location: St. Augustine,
FL
Cobra Make, Engine: E-M / Power Performance / 521 stroker / Holley HP EFI
Posts: 1,941
|
|
Not Ranked
Hello Gerry,
I have the MSD 8577. Here: http://www.msdignition.com/dist_19.htm
I didn't measure from the manifold because we may not have the same manifold, so I measured up from the block: 9-1/8" to the top of the plug boots which are the MSD right-angle ones.
The tape had to bend a little to get from the block (next to the distributor hold down clamp) up the to top, so the actual height may be a fraction less.
This distributor is the smallest for the 385 I could find!
Tom
__________________
Wells's law of engine size: If it matters what gear you're in, the engine's too small!
|
Threaded Mode
