05-23-2008, 10:34 AM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Mar 2000
Location: St. Augustine,
FL
Cobra Make, Engine: E-M / Power Performance / 521 stroker / Holley HP EFI
Posts: 1,947
|
|
Not Ranked
Andy,
Byron's giving good advice.
So I have to raise my hand on the other side of the room 
I use a Crane hydraulic roller setup, #359351. It has more than 20,000 miles, combined street (mostly) and track. I like it a lot!
Quote:
|
to keep the push rods from moving about
|
Did you mean what I would call pushrod guide plates like these perhaps?
429/460 Ford Guide Plates and Rocker Studs
I chose this URL for the photo - I use the 3/8" but not from Speedway. Much better to get them from Ford Racing parts or Jegs or Summit.
Ain't this fun?
Tom
__________________
Wells's law of engine size: If it matters what gear you're in, the engine's too small!
|
Threaded Mode
