New McLeod Hydraulic Clutch Conversion Kits...

[blykins]

I wish I could help out further, but it's hard to diagnose/troubleshoot when I'm so far away.

I do know that the majority of hydraulic clutch travel problems is due to air in the lines, but I know that you said that you bled it multiple times.

Did you talk to someone with McLeod's tech support?

[Great Asp]

I assume when you install the hyd throw out bearing that the bleed line is up.

Correct?

E

[einstein1982]

Originally Posted by blykins

I wish I could help out further, but it's hard to diagnose/troubleshoot when I'm so far away.

I do know that the majority of hydraulic clutch travel problems is due to air in the lines, but I know that you said that you bled it multiple times.

Did you talk to someone with McLeod's tech support?

Haven't talked to anyone there yet. I had bought it from you so I just wanted you to be in the loop.

I did write them to find out specs and stuff. Didn't know I was getting less then specified travel when I wrote them though

Originally Posted by Great Asp

I assume when you install the hyd throw out bearing that the bleed line is up.

Correct?

E

Honestly, I don't recall, but I'll try to remember. If that would make 0.150" - 0.200" different on travel, I'll put It all back together and try it.

I'll message McLeod with the issue.