Club Cobra
Page 1 of 3 1 23
Show 20 post(s) from this thread on one page

Club Cobra (http://www.clubcobra.com/forums/)
-   ALL COBRA TALK (http://www.clubcobra.com/forums/all-cobra-talk/)
-   -   Has anyone connected TKO 600 vent to an oil puke tank? (http://www.clubcobra.com/forums/all-cobra-talk/104312-has-anyone-connected-tko-600-vent-oil-puke-tank.html)

dcdoug 05-04-2010 10:13 AM
Has anyone connected TKO 600 vent to an oil puke tank?
 
Has anyone connected a TKO 600 vent to an oil puke tank? Is there an easy way to remove the cover so you can install a fitting like you can on the top loaders?

patrickt 05-04-2010 12:11 PM
Quote:
Originally Posted by dcdoug (Post 1048489)
Has anyone connected a TKO 600 vent to an oil puke tank? Is there an easy way to remove the cover so you can install a fitting like you can on the top loaders?
I have never heard of that. I have heard of the vent getting jammed shut though on installation and causing leaks out of the speedo cable area.

dcdoug 05-04-2010 12:24 PM
Quote:
Originally Posted by patrickt (Post 1048524)
I have never heard of that. I have heard of the vent getting jammed shut though on installation and causing leaks out of the speedo cable area.
I don't have any problems with leaking I am trying to correct, I'd just like to install an oil puke tank and run the lines correctly. I could always cap the tranny vent fitting on the puke tank, but I'd rather hook it all up if possible.

patrickt 05-04-2010 12:27 PM
Quote:
Originally Posted by dcdoug (Post 1048525)
I don't have any problems with leaking I am trying to correct, I'd just like to install an oil puke tank and run the lines correctly. I could always cap the tranny vent fitting on the puke tank, but I'd rather hook it all up if possible.
OK, maybe somebody here has heard of doing that with a TKO, but I haven't.

Excaliber 05-04-2010 01:20 PM
I've heard of some folks venting the rear end to the trans, via a Y fitting/adaptor/tubing, I guess. In some cases that resulted in rear end gear oil being pumped into the trans, not good. Defective rear end to be sure, but, whatever. End result, rear end gears went bad. Might not have happened if you could SEE the leak! For the same reason I wouldn't want to vent my trans to a puke tank. IF oil is coming out of the vent (trans or rear), man I want to KNOW about that right away! :)

vector1 05-04-2010 01:22 PM
i had a 3550 leaking oil out the front seal and between the main pieces. when i took the pipe fill plug out it made a sound like it was air tight. i guess the top breather was jammed against the panels up top. so i drilled a hole in the fill plug then put a wire in it so it wouldn't leak too much, didn't work, leaked too much. next put a fitting on it and strung the 1/2" x 2 ft. line up over the tranny and it leaked as bad, oil all over the tunnel and rear. so i drilled and tapped a hole on top of the shifter and put a drilled pipe plug in it with a rtv'd cap on top with a hole in the side to keep any water out. works this way, plus i can use it for a fill point. tranny doesn't leak now either,

patrickt 05-04-2010 01:32 PM
Quote:
Originally Posted by Excaliber (Post 1048537)
I've heard of some folks venting the rear end to the trans, via a Y fitting/adaptor/tubing, I guess.
Man, I've never heard of that either. And intuitively that makes no sense whatsoever.:LOL: On the rear though, I have a PVC tube vent that runs about six or so inches straight up from the pumpkin to allow venting without losing oil. Short of running it to a cooler of some sort, I don't know why you'd ever do it differently.

patrickt 05-04-2010 01:39 PM
Here's a pic, just in case anyone's interested....

http://www.clubcobra.com/photopost/d...earvent001.jpg

Excaliber 05-04-2010 01:57 PM
I THINK such a vent method (rear to trans and back at ya) may have something to do with racing specs? Same may apply to the puke tank, keeps oil off the track.

dcdoug 05-04-2010 03:10 PM
Quote:
Originally Posted by patrickt (Post 1048544)
On the rear though, I have a PVC tube vent that runs about six or so inches straight up from the pumpkin to allow venting without losing oil. Short of running it to a cooler of some sort, I don't know why you'd ever do it differently.
The diff was vented to the oil puke tank as well, but its easy to do in this case because you have a fitting that you can use. The oil puke tank has a fitting for venting both the diff and tranny, if you want to set it up like the originals.

I may just plug the puke tank and run a fake line down and connect it to a tranny bolt or something so it looks real....don't tell anyone. :LOL:

We'll see. Still just thinking about this as another project to mess with.

ERA Chas 05-04-2010 03:26 PM
Quote:
Originally Posted by dcdoug (Post 1048571)
We'll see. Still just thinking about this as another project to mess with.
Doug,
That's how a project becomes a crisis. Adding hokey BS will add complexity where you don't need it and cheapen the car.

Have confidence that your car is 'cool' enough-you're not running laps at Riverside and you're not going to SAAC for judging.

Excaliber 05-04-2010 03:28 PM
I think a fake line down to the trans is a good point for "keeping it real". I won't tell a soul... Likewise, don't tell anyone I broke down and put a TKO in, I'm SO embarrased by it all. :)

patrickt 05-04-2010 03:43 PM
Quote:
Originally Posted by Excaliber (Post 1048577)
I think a fake line down to the trans is a good point for "keeping it real". I won't tell a soul... Likewise, don't tell anyone I broke down and put a TKO in, I'm SO embarrased by it all. :)
We have someone around here that has fake fuel pumps in the trunk to mimic the originals. I can't remember who, though....

dcdoug 05-04-2010 03:45 PM
Quote:
Originally Posted by Excaliber (Post 1048577)
I think a fake line down to the trans is a good point for "keeping it real". I won't tell a soul... Likewise, don't tell anyone I broke down and put a TKO in, I'm SO embarrased by it all. :)
It's funny the things that we care about with these cars. I never gave a top loader more than a little bit of thought as I wanted a better highway cruise experience than that. Easy to make that trade off for me, although a TKO is a lot bigger difference than not having an oil puke tank....:LOL:

I have the same TKO that you do and love it. MUCH better than having a 4 spd IMHO.

Same with oil pans. I'd love to have an Aviaid, but don't want to deal with pulling the engine when there is a leak, so I went with the Canton. But yet I had a drain-back fitting welded on in case I installed an oil puke tank..:JEKYLHYDE

patrickt 05-04-2010 04:26 PM
Quote:
Originally Posted by dcdoug (Post 1048583)
It's funny the things that we care about with these cars.
You're absolutely right. And if running a line down to the side of the trans. makes you happy then more power to you. We all do little stuff like that to our cars, and, the truth is that nobody notices it except ourselves.

ERA Chas 05-04-2010 04:54 PM
Quote:
Originally Posted by patrickt (Post 1048595)
We all do little stuff like that to our cars, and, the truth is that nobody notices it except ourselves.
Uhhh-we can all notice what was done to your car...:CRY:

Excaliber 05-04-2010 05:24 PM
Quote:
...the truth is that nobody notices it except ourselves.
That's enough, for me. It's kind of like when you were a kid and building models. Sometimes I'd do it right by the book, sometimes I'd go wild with modifications. But one thing was always the same, I did it for ME, not to impress somebody else.

patrickt 05-04-2010 05:27 PM
Yep, as the ricers ask "is the engine supposed to sound like that?" as my solid flat tappets proudly tick away....:LOL:

dcdoug 05-04-2010 06:15 PM
I'm not really trying to impress anyone. Just adding some touches I think would add to my personal enjoyment of the car.

patrickt 05-04-2010 06:21 PM
Quote:
Originally Posted by dcdoug (Post 1048635)
I'm not really trying to impress anyone. Just adding some touches I think would add to my personal enjoyment of the car.
... and there's nothing wrong with that at all. Remember, these are just expensive toys -- no different than a Hot Wheels collection from when we were kids, except it just costs a whole lot more.:cool:


All times are GMT -7. The time now is 11:58 PM.
Page 1 of 3 1 23
Show 20 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.0
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.6.0
The representations expressed are the representations and opinions of the clubcobra.com forum members and do not necessarily reflect the opinions and viewpoints of the site owners, moderators, Shelby American, any other replica manufacturer, Ford Motor Company. This website has been planned and developed by clubcobra.com and its forum members and should not be construed as being endorsed by Ford Motor Company, or Shelby American or any other manufacturer unless expressly noted by that entity. "Cobra" and the Cobra logo are registered trademarks for Ford Motor Co., Inc. clubcobra.com forum members agree not to post any copyrighted material unless the copyrighted material is owned by you. Although we do not and cannot review the messages posted and are not responsible for the content of any of these messages, we reserve the right to delete any message for any reason whatsoever. You remain solely responsible for the content of your messages, and you agree to indemnify and hold us harmless with respect to any claim based upon transmission of your message(s). Thank you for visiting clubcobra.com. For full policy documentation refer to the following link: