Windage Tray needed

cobrakiwi · #1 (**permalink**) 06-30-2010, 04:28 PM

Hi

Any body have a windage tray for the Aviaid oil pan they would like to get rid of?
I need one for my build, got the pan just need the windage tray.
Thanks

mickmate · #2 (**permalink**) 06-30-2010, 06:41 PM

Do you need the pan that bolts inside the oil pan or the tray that sandwiches between the pan and the block?

cobrakiwi · #3 (**permalink**) 06-30-2010, 06:43 PM

The tray that goes between the block and pan,
Thanks

mickmate · #4 (**permalink**) 06-30-2010, 08:10 PM

I use these http://www.summitracing.com/parts/FMS-M-6687-A390/
I put a hole in them for the pickup brace to go through.

aviaid · #5 (**permalink**) 03-10-2011, 08:12 AM

Try the source.

Jerry Clayton · #6 (**permalink**) 03-10-2011, 08:23 AM

Good to see you on here John, this is probably the largest collection of people that should be using your stuff.

Jerry Clayton
Keeling & Clayton California Charger

MaSnaka · #7 (**permalink**) 03-10-2011, 01:09 PM

The windage tray listed from Summit is listed as N/A (not availible). I had heard ford discontinued them.

John

aviaid · #8 (**permalink**) 03-10-2011, 01:28 PM

We make our own part from 16ga steel, weld in directional screen in the 4 rod throw windows, and make provision to bolt on our custom pickup. The assembly is then Cadmium, not Zinc, plated. The part is sized so that once everything is assembled you can lay a bead of clear silicone, our sealant of choice, on the gap between the pan and the block all the way around the outside, then with your finger smooth off the excess al the way around, just like caulking tile. If anything leaks once that's set up, it' sthe rear main seal.

Credit for that method goes to Tony at Keith Craft.