11-24-2010, 08:27 PM
|
 |
CC Member
|
|
|
Join Date: Jul 2005
Location: Bartlett,
Ill
Cobra Make, Engine: Everett-Morrison LS1
Posts: 2,448
|
|
Not Ranked
That's because there are no lock washers!!!!
Brent, if you are going to do many of the LS series engines you need to get a couple of the Snap On TechAngle torque wrenches---3/8 drive goes to around 75# and the 1/2 drive goes to 250# I think--they can be set for the torque value plus the angle, will beep and show you the torque and angle reached---little bit $$$$$$ but something you need if doing work on these engines----
Wait till you get to the dampner bolt!!!!!
|
Threaded Mode
