02-14-2011, 10:59 AM
|
|
CC Member
|
|
|
Join Date: Apr 2008
Location: Near Chichester, Sussex by the sea......,
UK
Cobra Make, Engine: Crendon 427 S/C 428 FE+toploader
Posts: 668
|
|
Not Ranked
I reckon it could be possible, ............
assuming you can pull the dash out a little, and that there is enough capillary tube on those gauges to allow them to be pulled forward so that the bezel is proud of the dash surface by 1/2" or more.....
then I think you'd need to precut all the holes very neatly, and be located exactly where they need to be. If your dash is like mine (moulded, but not padded GRP), then it ought to be possible to prise the vynil naugu stuff over the chrome rim and make it stick down in the recess below the gauge. If you were a mm or 2 out wouldnt matter as the bezel will hide it. But it's going to be a tough call to get a complete set of holes in the right place imho.
be interested in how you get on, as i anticipate being in the same situation next year.
Last edited by KevinW; 02-14-2011 at 11:03 AM..
|
Hybrid Mode
