KIRKEY Vintage Seat

[Fullchat289]

Hi.

I used a set of the Kirkey "L-shaped" mounting brackets ($50 from JEGS) and am using ERA sliders with them.
Trick is to orient the flange of the "L-shaped" mounting bracket away from the seat and then you should be able to mount the seat as close to the floor as you want it. I used a couple pieces of corregated cardboard to set the height before marking my hole locations in the sides of the seat. One thing I should mention here though - I was able to do this b/c I can fit in the 15" seat and the ERA floor was just wide enough. If you need to go wider on the seat, I'm not sure what your NAF will allow..

- Allen.

[G-Pete]

Sliding was my choice...

Seat sliders from Speedway ($16 on sale)



60 inches of 1x1 inch tubing

[G-Pete]

mounted on the bucket



the seat sits on the stud protectors (black). The studs makes it possible the change the lean angle.

[cobra 53]

Thanks Allen and Pete.

Good base to start.

Rico