Oil Temp Probe

[PaulProe]

Patrick
Mine is exactly like yours, except using Autometer gauge. I am guessing yours is another brand? Other than that, looks identical.

I am using the typical FL1 filter on a remote bracket. Determined the level by putting 7 quarts into the pan (Canton calls it an 8 qt system) and then marking the dipstick. I then added enough oil to fill the filter/lines/oil cooler to bring it up to that mark.

Guessing that is a little too low. Spoke to Canton today and they recommended adding a 1/2 Qt. of oil. They were guessing there is enough windage from the big block that it is sucking the oil away from the probe. I am using the Canton 20-938 screen type windage tray. Allows quick return of oil but they say it isn't as effective as their new louver type.

Been searching the FE Forum, trying to find a correct oil level. Wish someone could tell me the distance from the pan rail to the oil surface on a stock motor. By the number of threads regarding this, looks like I am not the only who would like to know this dimension. You'd think after five years, someone would post an answer.

Trying to avoid issues from Over-Filling

Paul

[patrickt]

Originally Posted by PaulProe

Patrick
Mine is exactly like yours, except using Autometer gauge. I am guessing yours is another brand? Other than that, looks identical.

Mine is a Smiths mechanical. Do you have the oil feeds in the heads restricted? If not then you might be filling up up-top and that could be the whole problem.

[PaulProe]

Originally Posted by patrickt

Mine is a Smiths mechanical. Do you have the oil feeds in the heads restricted? If not then you might be filling up up-top and that could be the whole problem.

Oops, meant to post that info: Heads are restricted to .060 on each side. Topside isn't filling up with oil, I have some cut-off valve covers and have observed oiling action at topend. Not an issue, it is draining down ok and not accumulating.

Paul

[patrickt]

Originally Posted by PaulProe

Oops, meant to post that info: Heads are restricted to .060 on each side. Topside isn't filling up with oil, I have some cut-off valve covers and have observed oiling action at topend. Not an issue, it is draining down ok and not accumulating.

Paul

Huh. And the temp on your mechanical gauge goes up significantly in, say, 30 seconds after you shut the engine off and, presumably, the oil level in the pan has now risen up to touch the sensor? I would think the "hurricane" of oil around the sensor would be good enough to give it an accurate reading, but maybe not.