02-10-2014, 02:01 PM
|
 |
CC Member
|
|
|
Join Date: Dec 2011
Location: West Chester,
PA
Cobra Make, Engine: ERA #795 427 S/C completed Jan. '14 - '68 FE 427 side oiler
Posts: 1,059
|
|
Not Ranked
Hi Lippy,
I initially thought my rubber hangers were too short as well. Turns out there is considerable variation regarding where the bottom of the body is trimmed. Mine wrapped around considerably and was preventing the hangers from mounting at the correct angle (the 45 degree corner goes against the floor). After speaking with Doug, I took my Dremel tool and notched the body to allow the hangers to position correctly and that did the trick. As it turned out, that was good practice for enlarging the body opening I mentioned earlier.
Kevin
__________________
"Anyone who drives faster than you is a maniac and anyone who drives slower than you is an idiot" - George Carlin
|
2Likes
Threaded Mode
