Driving Lamps

[BAsque1]

Originally Posted by Widows Son

I had a friend fabricate a bracket using channel and angle iron. The holes allow me to fit the lamps at various distances from one another. Last, this design does not accommodate an oil cooler - which I'm OK with.


This picture is facing the front of the car:



This is side is to the rear of the car:

So you attached the fabricated bracket to the frame of the car not the fiberglass nose right?

[Widows Son]

Originally Posted by BAsque1

So you attached the fabricated bracket to the frame of the car not the fiberglass nose right?

Nope, I fastened it to the nose with rubber grommets. I had concerns about that, but the weight is very very low while the nose was very rigid. Is it ideal? Nope. I was contemplating a support bracket from far left wall to far right wall this would have also allowed for an oil cooler to be installed. That said, the width would have to be perfect and since I wasn't fabricating the frame, didn't want to have it come out too short or long in length after going through too much fabrication work. There were some other challenges as well.