06-29-2016, 06:22 AM
|
 |
CC Member
|
|
|
Join Date: Feb 2000
Location: St. Lucia, West Indies,
WI
Cobra Make, Engine: Unique 427SC 383 stroker
Posts: 3,787
|
|
Not Ranked
Double checking my halfshaft measurements this morning, I noticed that the yokes on either end of the shafts are not aligned in the same plane, ie: if the yoke on one end is laying flat or perfectly horizotal, the other end is at a 35 to 45 degree angle. In every single photo of halfshafts that I look at, whether stock length or shortened, the yokes are aligned in the same plane. Does this indicate that my shafts have been twisted? It's a sobering thought if that is the case. 
__________________
Tropical Buzz
Grant me the serenity to accept the things I cannot change, the strength to change the things I can, and the wisdom to know the difference. -(wasn't me)
BEWARE OF THE DOGma!! Dogmatism bites...
|
1Likes
Threaded Mode
