12-13-2008, 12:29 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: May 2007
Location: San Clemente,
CA
Cobra Make, Engine: CSX 4758, CSX 381 Keith Craft 482 w/ Weber 48 IDA's
Posts: 492
|
|
Not Ranked
767
I went out and took this picture of the fuel pumps and tried to look on top of either of them and all I could make out was "Genuine ...... Made in USA". I looked all around and under them with a small mirror and couldn't see any numbers. You might want to call the Cobra shop manager, Tony, at SAI or Bud in CSX parts. I looked at the facet-purolator website and it appears the FEP 59SV is what these are.
If you're running a Holley or similar carb, no regulator needed. They put out about 6 psi. I think these are -8 AN fittings on 3/8" ID line. No return line. Good luck.
Last edited by rokndad; 12-13-2008 at 12:45 PM..
|
Hybrid Mode
