02-15-2009, 11:17 AM
|
 |
CC Member/Contributor
|
|
|
Join Date: Feb 2000
Location: Greenville,
SC
Cobra Make, Engine: 70 Shelby convertible, ERA-289 FIA, ERA 289 roadster hybrid, mystery Ford powered 2dr convertible
Posts: 12,777
|
|
Not Ranked
Karl,
How goes the paint stripping on CSX2498?
Also, did you get my text page this morning about your welder issue? If not what I asked was how old your gas cylinder and valve are, as I just replaced a 4 year old valve because the gas was cutting out. Thought it was the welder, but turned out to be the valve on top of my cylinder (go figure). Just a thought.
Bill S.
PS: Then again, if the welder is not working properly, it's as good an excuse to "upgrade" 
__________________
Instead of being part of the problem, be part of a successful solution.
First time Cobra buyers-READ THIS
|
Threaded Mode
