09-17-2009, 09:14 AM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Mar 2000
Location: St. Augustine,
FL
Cobra Make, Engine: E-M / Power Performance / 521 stroker / Holley HP EFI
Posts: 1,935
|
|
Not Ranked
Here's a picture of the previous generation (III?) Everett Morrison frame showing the welded pads for the roll bar mountings. Two bars are attached (not installed yet): 
The attachments are above and in front of the gas tank. They consist of rectangular, horizontal pads with attachment holes drilled in them.
The frame has been changed, but an equivalent is made by Power Performance.
Note: the roll bars are stainless and stout. Possibly 3/32" wall tubing?. Unfortunately they were tested. They worked!
Tom
__________________
Wells's law of engine size: If it matters what gear you're in, the engine's too small!
Last edited by Tom Wells; 09-17-2009 at 11:48 AM..
|
1Likes
Threaded Mode
