anybody out there??

[pester]

just purchased and arnst cobra...have lots of questions..... help?!....

[cycleguy55]

Originally Posted by pester

just purchased and arnst cobra...have lots of questions..... help?!....

You'll probably get a better response if you actually post your questions.

[pester]

sorry new to this forum......i have a sbc z28 302 set way back in chassis...need new headers from engine out to second exhaust section. anybody know of source for these headers?

[pester]

also....i need to change distributor...any tricks in getting it out?

[spdbrake]

Finding an off the shelf set of headers for your particular model of replica and then in a SBC fitment will be tough if not impossible.

I'd contact LHT Performance as they have a good rep and are probably less than 10 miles from you.

Custom Built Headers

[joyridin']

These guys built the headers for my Arntz when I put in the LS3. They did a great job. No generic header will fit due to the location of the engine. They cost about $1200 in SS.

Go with a local place first, but if you have no luck, give these guys a call.

https://www.gpheaders.com/

[GVS]

@pester did you get your exhaust sorted? What other questions do you have about your car? This forum does not get a lot of traffic but it seems to be the only place for Arntz/Butler Cobra information.