So it begins ...

[Tenrocca]

I did ask the seller about it and it is titled as a 65.

Either way I dont think torsion and beaming testing is a big a deal as everyone thinks. Didnt I see someone in here make up a rig to do it? Apart from having that test already done and not having a relatively simple (I would think at the bare chassis stage) LHD to RHD conversion I reckon the USA kits are a very attractive option.

[Zedn]

I was quoted $1800 for the B&T test.

There is a clubby company who hire out the jig to do it for much less than it would cost to make. It is very basic to make, but you need about 10 dial gauges that are calibrated and also the weights to load it up.

[albanycobra]

I have built a few torsion testing machines over the years and tested a lot of cars. This is one is still in service. The rig set up is straight out of the NCOP.

[Jethrow]

OMG the waiting .....

The wait between ordering a kit and getting it is starting to drive me nuts! I am using the time trying to get ready, shed organise etc, but still, it would be cooler to have a box marked cobra sitting in the drive.