03-04-2011, 03:51 AM
|
 |
CC Member
|
|
|
Join Date: Jul 2004
Cobra Make, Engine: 347 Stroker Morrison Injection. Registered.
Posts: 1,440
|
|
Not Ranked
Great improvement with the steering shaft exiting in the right place. As far as the door alignment goes, your car looks perfect. When mine arrived the door on the drivers side was fairly flush on the dash end but sat up 25mm on the latch side. To fix it my glassman had to expose the 50mm square tube/fixing plate that the sticker attaches to, remove it, cut it of from the metal plate that bolts on the floor that comes fibreglassed in, shorten as needed, reweld and re fibreglass in. As well as this the curved section behind the drivers seat was nearly flush with the body that runs over the back wall of the cockpit then curves down. My guy had to cut the curved section behind the seat into 10mm stripes from top to 3/4 down, spread them at the top to get some overhang to hide the carpet edge that would be installed later, then reglass everything back together. Don't get me going.
DaveW please keep posting pictures, we love to see how your going!
Regards.
__________________
Mando
|
Hybrid Mode
