BRM knock on wheels forsale

[Modena]

Originally Posted by Aussie Mike

Holden stud patern is the same as Jag (4 3/4" PCD). Just have to check if the pin drive adapters will go over your hubs. If they are anything like mine then they should fit over the Jag hub spiggot.

Cheers

Depends what you mean by "Holden", old Holdens (HQ'esque) 4.75" (120.65mm) while Commodore is 4.724" (120mm), subtle but important difference.

[albanycobra]

The wheels are chev/ jag pattern, but they are fitted to holden hubs.
So designed for chev/ Jag but fit on Holden aswell. Wheels are made and designed in the USA
by Vintage Wheels.

[Gav]

Originally Posted by Modena

Depends what you mean by "Holden", old Holdens (HQ'esque) 4.75" (120.65mm) while Commodore is 4.724" (120mm), subtle but important difference.

The major difference is the threads on the studs, commodore are metric. I have fitted plenty of commodore wheels (widened interceptor rims, with the offset adjusted) to HQ-WB's and have never had an issue.
Wheels are not drilled/stamped within 0.6mm accuracy!

[Towmaster]

Any idea of the back spacing?

[albanycobra]

Backspace fronts 4inches
Backspace rears 4 inches.

I have taken pics of how I measured back space if you get serious.
But basically the measurement is from where the wheel mounts hub to back lip of rim.



Cheers
Dave