Taller Inline Radiator Filler

[muzzza]

Tim, Have a couple of pics of my header tank set-up in my gallery. .........works really well. Moroso header tank feeds into thermostat / heater housing, with another Moroso tank purely as an overflow. I run coolant about 40mm down from top of tank and it has never expelled coolant into the overflow tank. I also run the 63 deg thermostat. Murray

[Jethrow]

Originally Posted by muzzza

Tim, Have a couple of pics of my header tank set-up in my gallery. .........works really well. Moroso header tank feeds into thermostat / heater housing, with another Moroso tank purely as an overflow. I run coolant about 40mm down from top of tank and it has never expelled coolant into the overflow tank. I also run the 63 deg thermostat. Murray

Thanks Murray. Looking at your photos, your install looks really neat. I also like how you added a temp probe in the other heater outlet point. I put mine on the other side of the water pump where there is a blanking plug.

On a different subject how easy is it to fit those valve covers? I have considered getting a set but am unsure on how they fit, especially with what to do with the coil packs. Ideally they will stay in the same point they are now, but I am not sure if those covers fit over the top or not.
Thx

[muzzza]

Tim, They were a bit fiddly to fit. Edelbrock say they fit LS2 but depends on what coils you have. They apparently were designed for the LS1 coils, which are a little smaller. I had to muck about and make some small adapter brackets to get the standard LS2 coils to fit.....worked out OK though. Murray