12-01-2014, 01:10 AM
|
 |
CC Member
|
|
|
Join Date: Jun 2009
Location: Sydney,
NSW
Cobra Make, Engine: RCM, Jag front and rear, LS3
Posts: 1,640
|
|
Not Ranked
I have the psi loom in my car.
It took ages to come around 4-5weeks from memory. I didn't care as I wasn't up to needing it.
The loom looks to be well made.
As its universal, the lengths of each section were very long. Also the conduit used was quite large. I unwrapped the whole loom, shortened the wires and re wrapped in smaller sizes of conduit.
The connector or accelerator is US and will not fit Australian accelerator pedals. Trying to find a replacement connector proved impossible so I made my own.
I found there was no vehicle speed sensor connector included even though it was shown in the instructions and marketing material. When I contacted them was told I had to pay for one if I wanted it and it would be grossly over priced. I needed it cause my guages use the signal. Bought one of eBay for half what he wanted to charge.
Car fired up first go.
|
3Likes
Threaded Mode
