08-02-2015, 01:57 AM
|
 |
CC Member
|
|
|
Join Date: Jan 2001
Location: Sunbury,
VIC
Cobra Make, Engine: Rat Rod Racer, LS1 & T56
Posts: 5,391
|
|
Not Ranked
I can see the problem. The feed in pipe is pointing straight at the drivers side. How about putting a partition in the plenum just after the feed in pipe that fills the bottom 1/2 of the channel that would force some of the air to do a u turn up the other side of the channel and even out the balance. Try cutting a piece of ice cream container and taping it in place to work out the right height.
Cheers
__________________
Mike Murphy
Melbourne Australia
|
4Likes
Hybrid Mode
