LS1 fly by wire plugs

[sideshow]

ok cool i will enough to make 5 looms

but i need to know what stage do u want the loom to be finished too

do u just want it to fit to sensors on engine

or do u want all relays and fuses fitted so all there is left is afew wires for batt ign feul pump radiator fan etc etc

to make the loom fully complete will be around 550 this includes 3 to 4 relays and holders all plugs needed for the sensors and there will be a small plug left over with wires

all labelled and instructions supplied

or can do it bit cheaper without relays and fuses

thanks

jim

[Rebel1]

Jim, I've sent you three pics via email of the harness both Schipps and I have. This should enable you to identify whats on it.

Most connectors are obvious. However the harness tail (Pic 1 ) looks like it has some gearbox connectors. It also appears the holden harness has provision for the front O2 sensors but not the post cat O2's. Not that I really want them but may have to for compliance.

From my point of view I think I'd just want a fuel pump relay tail that I can run to where-ever it's gonna live and connect it myself to a relay in the boot. Same with the radiator fan.

I would want a small fuse holder box and of course an OBD port and a check engine light.

Speedo, Tacho and accelerator wires would also be wanted.....What else is there?.

Cheers

[Rebel1]

Mick, The mighty Maroons, was there any doubt?.

I heard on the news during the week that some woman captured a huge cane toad in Melbourne.

Give us time, we'll take over Australia yet.