
07-05-2009, 02:31 AM
|
 |
CC Member
|
|
|
Join Date: Apr 2008
Location: Melbourne,
VIC
Cobra Make, Engine: Classic Revival CR 3505, LS1, T56 6 Speed, VE 3.45 LSD Rear, 6 Spot AP Fronts, 4 Spot Wilwood Rears
Posts: 1,121
|
|
Not Ranked
Quote:
Originally Posted by Merv and Sharon
There is so much variation possible on these inspections: do you need a grille, bumper bar, or emissions testing? Sometimes, yes sometimes no. I am going to keep ringing every week to see if I can get an earlier inspection time from a cancellation.
Thanks for the support.
Merv
|
Hi Merv,
Keep plugging away at "the Bureaucracy", you might get a break and sneak in earlier on a cancellation.
Speaking of variation, my inspector said "where's your front number plate illumination?". I said I've never seen a car with one and he ignored me and just kept in inspecting, I think he was trying me on. I just kept my trap shut after that.
Good luck.
I am about a week away from sending to the painter which takes about 2 months (sanding and painting). Lucky its damn cold and wet down here and I cant drive it so I wont miss it too much. Will be ready for summer.
Took it for a test drive tonight (just a shade over 10 degrees) after upgrading my Brake lines (little longer and braided) and pads to RB74 (front) and comp2 (rear) - stops real good now. After a few hard stops the brakes are only just getting slightly warm.
Rgds
Gregg
|