03-10-2003, 03:52 PM
|
|
CC Member
|
|
|
Join Date: May 2001
Location: niceville fl,
fl
Cobra Make, Engine: Hunter #28; 396 Cleveland stroker; more than 495 HP; TKO 5 speed
Posts: 442
|
|
Not Ranked
another "look out for" Make sure your header "height" from the floor is the same on both sides
don't cut body out until motor mounts are fixed/finished.
After everything was welded/cut; I notice the motor was'nt perfectly level, side to side. I needed a 3/16 in shim to make it perfectly level, because of the moment arms it changed the header "height " 1.0 in; effecting my cutout.
gn
|
Threaded Mode
