Cobra Make, Engine: built the molds and body composite construction
Posts: 326
Not Ranked
Cowling
Check out the Winter 2020 issue of RECARNATION magazine, on page 34 is the article Cobra Cowling. This should answer a lot of your questions.
If you are not getting a hard copy of the magazine (it's free) then check it out at rcnmag.com
Not sure what year yours is but my 2013 is fine in the front. It is the back flat pan with round hole in rear. The pan should taper and be a little deeper in my opinion . The taper would help the air to move and create less turbulence. The very least ,it should have some pressure relief vents installed, in the rear.
Radiator panel
Linear Mode
