02-27-2006, 04:40 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Feb 2006
Location: Crosby,
TX
Cobra Make, Engine: BDR #621, Keith Craft 408
Posts: 476
|
|
Not Ranked
I just complete the seat belt bezel project on my BDR. I kept the backing plates and struts to the trunk deck for extra support. Cutting the slots in the backing plates was a little tough. Even though the shoulder belts aren't use often, just getting those eyebolts out cleaned up the look. The project was a bit of a challenge due to the cramp trunk area. Needed to purchase a 90 degree attachment for my drill. I used the existing holes from the struts, enlarged to 25/64, tapped to 7/16-20 and done.
|
Threaded Mode
