10-30-2007, 12:14 PM
|
 |
CC Member
|
|
|
Join Date: Dec 2003
Location: Sandy,
UT
Cobra Make, Engine: FFR with a 345-horse 302 Crate Engine
Posts: 88
|
|
Not Ranked
I used a new T-5 tranny in my car and when I first started driving it after the build I had a leak from the tail shaft. I assumed it was a bad seal and installed two or three seals in an attempt to fix the problem. The leak persisted. I finally replaced the slip yoke on the drive shaft with a new one. That fixed the problem.
I don't think a welder is the answer to your problem.
__________________
Jim Doak
FFR 2117
|
Threaded Mode
