02-05-2005, 08:50 AM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Mar 1999
Location: Yuma, AZ / Whitefish, Mt.,
Posts: 483
|
|
Not Ranked
I just got done with the up grade and I will have to say the instructions were very good. I didn't remove the seats, tunnel or rear tires and was able to do the job in about 4 hrs. The only PIA was holding the nut on the forward mounts mine is an older car so the nuts were not welded to the frame. Had to take a off set 3/4 box end and cut it in half. 3/4 will fit a 17mm. My kit did not come with the nylok nuts even tho they say to use them instead of the free spin they sent. Over all I would have to say it is a very good upgrade.
|
Hybrid Mode
