David Kee Transmissions

weekendwarrior · #1 (**permalink**) 12-31-2003, 10:09 AM

Bought a Toploader from David, Just wanted mention that David was very professional and the work was first rate. Very easy to go Online and order additional small parts needed in the build.

Thanks David

ENTDOC · #2 (**permalink**) 12-31-2003, 11:13 AM

I need to order one also.What exactly did you get. chuck

weekendwarrior · #3 (**permalink**) 12-31-2003, 12:07 PM

I got a TL with a Mustang tailhousing (I believe 14"), wide ratio gears, 1 3/8 input, 31 spline output, reverse speedometer gear (so I did not need the adapter). Told him I needed it for a Kirkham 427. Came UPS bolted into a stout returnable shipping container.

P.S. David will also need to know if you are going to use a hydraulic throw out bearing or a clutch fork. I am running a clutch fork and slave cylinder.

Gary

PatBuckley · #4 (**permalink**) 12-31-2003, 12:14 PM

Gary -

What rear gear are you going to use? I am using a 3.07 and am out of luck in being able to get the right drive/driven combination when I use the reverse driven gear.

Pat

weekendwarrior · #5 (**permalink**) 12-31-2003, 12:48 PM

Pat I have the 3.31's that came with the car. I have given up the idea of getting everything to my liking the first time around. The goal is to get it Registered and then tinker and fine tune as I learn. It's going to howl on the highway but what the ____.

I was told 3.31 would be ok with the reverse speedo gear - hope so.

Gary

Specialk · #6 (**permalink**) 12-20-2004, 06:58 AM

Gary,

I am building a Kirkham right now with a 3.31 rear gear. I am getting a DK Toploader with the reversed "drive" gear. Did you use a standard Ford gear? If so, what color or tooth count gear did you use? Will a standard rotation gear mesh with the reversed drive gear?

Enough questions for ya?

weekendwarrior · #7 (**permalink**) 12-22-2004, 03:17 PM

Quote:

Originally posted by Specialk

Gary,

I am building a Kirkham right now with a 3.31 rear gear. I am getting a DK Toploader with the reversed "drive" gear. Did you use a standard Ford gear? If so, what color or tooth count gear did you use? Will a standard rotation gear mesh with the reversed drive gear?

Enough questions for ya?

Kris,

I need now what you are asking, sent an email to DK, no answer, will call tomorrow

Gary