12-27-2021, 01:22 PM
|
 |
Senior Club Cobra Member
|
|
|
Join Date: Feb 2005
Cobra Make, Engine: Contemporary, FE, Tremec TKO 600
Posts: 1,990
|
|
Not Ranked
I have a Contemporary and my 4 post lift is too steep to get up without scraping. The folks at Race Ramps will custom make light weight foam ramps. I diagrammed a ramp that allows the metal ramp from my 4 post to sit on a lip of the Race Ramps ramp, which then extends out another 42" for a nice shallow incline. They charged me about $350 to make them if memory serves me right.
As for a floor jack, I have a low profile extended reach Daytona from Harbor Freight, it reaches the rear crossmember from the back, and both sides can be lifted as well. If I need to lift from the front I just drive onto the lightweight Race Ramp ramps, which also serve as regular ramps, and I can get the jack underneath the front from there. Also, I always use a hockey puck on the pad of the jack, it saves everything from getting scraped up.
Hope some of this helps.
|
28Likes
Threaded Mode
