05-16-2010, 03:27 PM
|
|
Registered User
|
|
|
Join Date: Apr 2010
Cobra Make, Engine: Contemporary 427/48 IDA
Posts: 15
|
|
Not Ranked
Today I finished up making a couple of vertical arms for the rear sway bar out of stainless, I put them on for a trial fit. The whole top assembly joint where the hiem end bolt - attaches to the swaybar is very close to the watts linkage, I think too close for my liking. Tomorrow I’ll remove the rear wheels, bolt everything down attach a couple of 3/4" clamps on the bar to prevent it from moving from side to side. But ultimately it looks like I’ll have to go the Speedway Engineering bar. (Probably for the best anyway)
The pics are crappy but you know what I mean.
\DSCF0461.JPG)
\DSCF0459.JPG)
\DSCF0463.JPG)
Last edited by NFS; 05-16-2010 at 03:32 PM..
|
2Likes
Threaded Mode
