10-19-2010, 01:03 PM
|
 |
Half-Ass Member
|
|
|
Join Date: Jun 2005
Cobra Make, Engine: ERA #732, 428FE (447 CID), TKO600, Solid Flat Tappet Cam, Tons of Aluminum
Posts: 22,025
|
|
Not Ranked
Quote:
Originally Posted by rodneym
Patrickt,
Could you make more room by repositioning the spring end 'up' and shave off some of the fork? And replace the inlet. 
rodneym |
Yes. While my initial post had a little humor to it, the question is a little serious. I've got a new remote inlet on the way, but I think the fork has clearanced itself on the inlet as far as it's going to go. I just don't know how much more plastic I have left.  Pulling the MC, replacing the $6 inlet, O-Ring, and Clamp and then grinding off a little bit of the fork is the quality repair... I just don't know if I feel like doing that this year.  |
Threaded Mode
