
05-07-2015, 07:35 PM
|
|
CC Member
|
|
|
Join Date: Oct 2013
Location: Columbus,
OH
Cobra Make, Engine: ERA 714
Posts: 713
|
|
Not Ranked
Ok, so I stopped at Jegs and matched up a MSD Dynaforce 5093. Put it in cranked it. I then pulled it back out and just looked at the contact and it looked great. I did not need a shim. I put it back in and ran an extra ground cable and tried it a few times and it worked great. It was not a cheap started but it seems to have no problems turning the engine over. Now I just have to clean off the headers from my grimy hand prints, but I will wait till it cools down for that. Thanks for all the advice and I will report back in a few months.
Phil
|