Charging System Troubleshooting--Blown Ignition Light Fuse?

[ACHiPo]

[quote=patrickt;1461837]
Run a fused wire from the ACC terminal of your ignition switch (WHITE wire) to the exposed pin on the ignition switch that had the two green wires on it. The G/R wire should still be attached to the ignition light normally.

I assume you mean the exposed pin on the ignition light not switch?

[patrickt]

Originally Posted by ACHiPo

I assume you mean the exposed pin on the ignition light not switch?

Yes, that was a typo.

Originally Posted by ACHiPo

Talked to Bob. I am going to modify the VR connector to emulate the older design with out an ignition light, removing the "I" wire from the connector and jumpering "A" to "S". I will reinstall the fuse (which may blow again) so maybe I'll regain the use of my tach. Even if the fuse blows, I should be able to drive the car and have it charge (hopefully)!

Alright, that's pretty easy to do and we can always switch it back.